A Random Tip

You should pad the plunger of all reverse plunger blasters, as to not snap the plunger head, and to quiet the firing of the blaster.

~PopTart

Disclaimer

If you decide to do any of the mods you see here, do it at your own risk.

~PopTart

Raider Simple Mod's

I recently acquired my first raider, and I wanted to mod it. My only setback was, I had never modded a primary before. I preceded extremeley cautiously, and the mod come out successful. first it was a standard air restricter removal.


Then I found some kind of heavy metallic tubing, and I thought it would be perfect for a barrel. At first the tubing wouldn't go throught the hole in the front of the gun, so I had to widen it. I secured it with pumbers goop and I closed the gun up, test fired and it worked.


Finished Product

-PopTart

Singling a LongStrike

I had some cpvc scraps lying around, and then I saw my longstrike and one thing led to another. Sorry for the post mod pictures, I didn't think about it until I decided to do the write-up.

Let's Get it Started...worst way to start ever.

Materials Needed:
Longstrike
Screwdrivers
Sandpaper or dremel sandbit
CPVC and CPVC T thing
E-Tape and Plumbers Goop
Hacksaw or Dremel Cutting bit


Of course the first thing your going to need to do is remove the air restrictors.

Next, you're going to cut right behind that nub type thing on the bolt.

Then, put the bolt in the T. Sanding may be necessary.

After this, put some kind of priming handle, usually a length of CPVC, on the T and plug it with either foam or an endcap,which I did not have accessible.

The last thing you're going to do is cut the dart tooth receptive thingy (Seen in the picture below) so it can receive the barrel, a length of at least 4 inch CPVC.

It should end up looking like this.

Finished Product:

This performs on par with my singled longshot with a k26 spring.Happy Modding! Video

-PopTart

New Barrel System

Materials:    -Super Glue    -E-Tape    -Deploy Sight    -Standard Plunger(From a Disk Shot, Nightfinder, Switchshot, etc...) 1. Cut the Deploy sight to the dart length. 2. Cut the plunger head off completely. 3. Wrap E-Tape around the Deploy sight until it sits in the plunger. 4. Super Glue the sight into the plunger and wrap E-Tape around plunger and sight. This should increase range 57%. HAPPY MODDING  ~Blizzard